Browse DigiKey’s inventory of THS Evaluation ModuleOp Amps. Features, Specifications, Alternative Product, Product Training Modules, and Datasheets. Texas Instruments THS Linear – Amplifiers – Instrumentation, OP Amps, Buffer Amps parts available at DigiKey. THS Price, THS Stock, Buy THS from electronic components distributors. Instant result for THS
|Published (Last):||15 July 2012|
|PDF File Size:||13.81 Mb|
|ePub File Size:||17.36 Mb|
|Price:||Free* [*Free Regsitration Required]|
Ask a related question What is a related question? In reply to Darren Xu:. Do you have another question? Aug 1, 4: Hi again, May I ask that why the network analyzer show that chart.
And the noise still happened as follow thd3001 Locked Cancel Do you have another question? When reducing the gain, the noise was smaller. The blue and yellow graphs belong to two outputs of EVM board. In reply to Darren Xu: TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and ghs3001 with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a the3001 purpose, title and non-infringement of any third party intellectual property right.
Menu Search through millions of questions and answers User. If you have further questions related to this thread, you may click “Ask a related question” below.
The device could be made more stable by increasing the Rf value or R5 in your case to 1kohms or higher. Oct 18, 5: For measuring the frequency response of the THS EVM, you would have to setup the EVM in the below configuration for ohm input and output at the network analyzer.
This should indicate whether the noise is actually coming from the device or being picked up elsewhere from the environment. This ths30001 not the case for the output connector J3 because it seems to be referenced to GND.
We are glad ts3001 we were able to resolve this issue, and will now proceed to close this thread. In reply to Rohit Bhat: Do you have another question?
If you notice the S21 marker at Following is my Schematic diagram. Oct 14, In reply to Rohit Bhat:.
THS Price & Stock | DigiPart
Ask a related ths3001 What is a related question? I used the circuit to test my moudle ,the circuit gave by THS datasheet. I try to implement an amplifier, but my PCB board always falls in noise as following figures: Menu Search through millions of questions and answers User.
Aug 2, 5: Go to Support forums. How can I handle this problem? From the noise waveform attached, it does not look like the input being applied is properly referenced to GND and what you are seeing could be a Hum or GND bounce. It looks like the noise waveform you attached could be due to instability in the THS Aug 9, 9: If you have a related question, please click the ” Ask a related question ” button in the top right corner.
Go to Support forums. I also change Rf and Rg for ohm,but the problem does not change. Aug 3, All content and materials on this site are provided “as is”.
Hi Dinh, Would it be possible for you to make the R5 as 1kohms or higher and R6 as Mentions Tags More Cancel. We are glad that we were able to resolve this issue, and will ths30001 proceed to close this thread.